iSpring WGB32BM 3-Stage Whole House Water Filtration System w/Iron & Manganese Reducing Filter

  • Equipped with gradient three stage filtration, iSpring WGB32BM whole house water system removes sediment, chlorine, Iron, Manganese, rust, pesticides, herbicides, industrial solvents, VOCs, and various other contaminants. With 1 inch NPT inlet/ outlet, it has minimum impact on water flow (up to 15 GPM) and requires minimum maintenance.
  • Installed at the main water supply to treat all the water you use in your entire home. Enjoy better water from every tap and every appliance in the whole house. In addition to the basic features of sediment, chlorine and odor removal, this system also excels in the reduction of iron and manganese residue to protect your home appliances, such as the dishwasher and washing machine.
  • Unlike an RO system, this system will NOT reduce Total Dissolved Solids (TDS), thus it keeps the healthy minerals in the water.
  • The first stage high capacity polypropylene sediment filter achieves filtration down to 5 microns. The second stage CTO Carbon Block filter uses high quality coconut shell carbon for maximum filtration efficiency and filter life. Both are tested by independent third-party to meet NSF/ANSI Standards. Both filters have a capacity of 100, 000 gallon of water to supply one full year of clean water for a family of four.
  • The last stage FM25B iron and manganese removal filter efficiently reduces iron (3. 0 -> 0. 01 ppm) and manganese (1. 0 -> 0. 01 ppm), and lasts up to 3 times longer than greensand because the catalytic media is not being consumed in the process.
  • $509.99
    • Reviews (85)
    Qty:
        Eligible for FREE Shipping Orders Over $35 within US 48 cont. states Details    Print

    • iSpring Multi-layer filtration allows for less clogs and minimal pressure loss.

    • iSpring carbon block filter uses high quality coconut shell carbon and highly compact fabrication tech for maximum filtration efficiency and filter life.

    • iSpring iron manganese filter efficiently reduces iron (3.0 -> 0.01 ppm) and manganese (1.0 -> 0.01 ppm) and lasts up to 3 times longer than greensand.
      Filtration Capacity: 50k gal at 3.0ppm for iron.

    Frequently Asked Questions

    Q: With this whole house system, do I still need to install a water softener if my water is very hard?
    A: Yes, a water softener is needed if your source water has a high level of hardness, usually with TDS higher than 700 PPM. Hard water can reduce the lifespan of whole house water filter cartridges. The harder the water, the greater amount of scale buildup occurs, and the sooner the filters get clogged.
    This whole house water filter can remove 95% of sediment, chlorine, rust, pesticides, herbicides, industrial solvents, VOCs, and various other contaminants that a regular water softener can't, although it does not soften your water. It is recommended that you install this WGB32BM whole house system after your water softener to achieve optimal performance if you have hard water.
    To determine which product best suits your need, it is recommended that you get a professional water test done prior to purchase to identify the main issue of your source water.
    NOTE: Water Softeners and whole house systems usually do not lower the TDS level of the water. An additional Reverse Osmosis system may be necessary for your drinking water. Please consult iSpring professionals prior to purchase if you are unsure of which product will meet your needs.


    Q: What type of Whole House Water Filter do I need?
    A: If you are on municipal water that isn't contaminated with heavy metals like iron, manganese and lead, the WGB32B is the system to go with. Naturally occurring metals are a commonplace in most well water sources however, and that is where the WGB32BM or WGB32B-PB earns its keep. If you are on well water or have heavy metals in your municipal water supply, you may want to consider the WGB32BM or WGB32B-PB over the WGB32B. For removing the common contaminants found in the majority of municipal water supplies however, the WGB32B fits the bill.


    Q: How does this filter remove iron in the water? Does 6ppm to 0.01ppm apply to any water source?
    A: It depends on the quality of the source water. If the source water has a higher level of hardness, normally with TDS higher than 700, the resin in the filter could be saturated by Calcium, Lead, Magnesium and other cations, and would not be able to remove iron and manganese effectively. In this case, please install it behind a Water Softener that can either remove or neutralize these cations first in order to extend the lifespan of this FM25B iron manganese removal filter.


    Q: What flow rate should I look for?
    A: Measured in gallons per minute (GPM), flow rate determines the amount of water available to run your shower, toilet, hot water heater, dishwasher, etc. When calculating your requirements look at the demand ratings printed on your appliances and toilet. Depending on the size of your house and family your water flow rate requirements may range from 5 to 40 GPM.


    Highlight Features

      • 100,000-gallon capacity replaceable highly compact coconut shell activated carbon filter provides a full year of clean water for your entire family.

      • This whole house system removes up to 98 percent of sediment, chlorine, chloramines, chemicals, heavy metals and other contaminants that create color, foul tastes and odors. (Tested by SGS, 2018)

    • The WGB32BM is equipped with an iron and manganese filter, removing up to 99% of both contaminants. The filter is also capable of greatly reducing arsenic, however this will vary depending on the specific isotope. (Tested by independent third-party to meet NSF/ANSI Standards: 42, 53 for drinking water treatment units, 2018)


    Product description


    Style:Iron & Manganese Removal

    The WGB32BM whole house filtration system is the ideal "point of entry" filtration system for cleaning up well water. Unlike "point of use" systems (like reverse osmosis systems) that are installed to supply water to a specific faucet, the WGB32BM filters your water from the source. This means water from every output in your home will have passed through the three filtration stages of the WGB32BM.

    So what exactly do these three stages of filtration offer? Used as the first stage of defense on the system, the stage 1 housing holds a 5-micron high-capacity polypropylene sediment filter. This filter removes dirt and other various larger sized particles from the water that can clog the following filters. The second stage of the WGB32BM houses a 5-micron CTO coconut shell carbon block filter. Block carbon is more effective than other forms of carbon in that it is finely ground up carbon packed into a solidified block. This means they have a higher density than other types of carbon filters, and are therefore more effective in removing their targeted contaminants. The carbon block filter knocks out bad tastes and odors, removes over 90% of chlorine from the water, and is highly effective on organic chemicals (VOCs) like pesticides, herbicides, and industrial chemicals. The third stage of the WGB32BM has an iron and manganese reducing filter - also great for the plethora of heavy metals found in well water sources. The FM25B iron and manganese reducing filter is only included with the WGB32BM, as it is not needed for most municipal water supplies that the WGB32B targets.

    If you are on municipal (city) water or a generally clean water supply, you may want to consider the WGB32B over the WGB32BM. For removing the common contaminants and heavy metals found in the majority of well water supplies however, the WGB32BM fits the bill.
    • Availability: In Stock
    • Model: WGB32BM
    • Manufacturer: iSpring

    Write Review

    Note: Do not use HTML in the text.